Knox Video VS-200 - Manual (Page 25)

K NOX V IDEO VS-200 O PERATION M ANUAL
20
6.3 Audio inputs and outputs
This model supports audio switching, simultaneous with video switching. This
means that audio input 1 might switch at the same time as RGB1, audio input 2 with
YC1, etc. Each audio input connector can be configured to be ‘linked’ to a particular
video input connector, so that they switch together.
Once switched, the audio input connector is linked to the audio output connector with
no audio processing or buffering taking place. The only processing that is performed,
is ‘click-less’ operation.
On the back of audio-equipped units are 5 x 3-way connector blocks. These can be
removed individually (with care), or can be left in-situ whilst connections are made
(by releasing each terminal using a small screwdriver, and then by clamping it back
down again once a new cable has been inserted).
The diagram above shows the 5 connector blocks (as viewed from the rear of the
unit), each with Left, Ground and Right terminals.