Knox Video VS-200 - Manual (Page 31)

K NOX V IDEO VS-200 O PERATION M ANUAL
26
This menu may appear as either of the above – depending on whether the analog
and digital outputs are controlled separately.
This menu item allows you to select the type of signal output your unit will provide.
Types of output vary depending on the resolution selected and include various types
of component signals YUV or tlYUV (tri-level YUV) and the full range of RGB type
signals RGBHV, RGBS and RGsB (Sync on green).
Note that this value is remembered for each resolution – so you can set 1024x768
60Hz to RGBHV and 1280x720 60Hz to tlYUV and both will be remembered
separately. This value is not affected by a Factory reset – but is reset by a firmware
update.
This menu item is only available on certain units with an SDI output and when
locking to a CV or YC input. An internal de-jitter circuit ensures that the SDI output
has a low jitter over the full 10Hz to 100kHz range, even though the CV or YC input
may have a high jitter. However, this is not always compatible with a CV/YC output
where the colour sub-carrier should not be de-jittered and needs to follow a Lock
source’s input – hence it should be turned Off it the CV/YC outputs are going to be
used.
This menu item is only available when the Output resolution is set to PAL or NTSC.
With this you can change the output type to the PAL or NTSC standard with the
further option of changing the output to the additional PAL & NSTC standards such
as PAL-M or PAL-N. SECAM is also available as an output on some units, provided
the ‘Output res’ is set to PAL / 50Hz.
This menu item is only available on certain units when the Output resolution is set to
PAL or NTSC. With this you can change the output filtering system to increase or
decrease the image sharpness. In general, high sharpness can result in increased
colour disturbance.
Adjust outputs
Luma/chr BW [Med] / [Med]
Adjust outputs
Anlog= [RGBHV] Dig= RGBHV
Adjust outputs
Output type [RGBHV]
Adjust outputs
Optimize for SDI [On]
Adjust outputs
Stand. [NTSC-M/PAL-BDGHI]
Adjust outputs
Back Y/U/V [ 16] [128] [128]