Knox Video VS-200 - Manual (Page 49)

K NOX V IDEO VS-200 O PERATION M ANUAL
44
This menu item allows the adjustment of the serial baud rate used for RS-232
communications. The rate can be adjusted to 9600, 19200, 28800, 33600, 38800,
57600 and 115200. (This adjustment is provided for those instances where you wish
to use the RS-232 control system for your own purposes.) The default baud rate is
57600.
The screen labeled ‘Buzzer’ is actually the control for turning the “Beep” “On” or
“Off”. Normally this is left in the “On” position to provide positive feedback that your
data entries and parameter changes have been accepted.
This menu item changes the function of an attached CC-300 CORIOconsole unit.
When set to ‘On’ any ‘Take’ will result in the A & B windows (‘buses’) being swapped
at the end of the Take – so that another ‘Take’ will put them back to as they were
before.
This screen is an informational screen showing the total number of the defined
resolutions in the resolution database. Future firmware releases may increase the
total number of resolutions defined in the database.
If your units supports Logos or Testcards then this screen will display how many are
present in the memory of the units.
Power Cycles refers to how many times the unit has been powered since it left the
factory. This is an informational screen. No action is taken regardless of the value
shown here, however some users have an equipment cleaning or specification audit
procedure and this information may be useful to those users.
System
RS232 baud rate
[57600]
System
Buzzer [ On]
System
Resolutions 88
System
Power cycles 41
System
Logos / T-cards 1 / 4
System
CC-300 A/B bus mode [ Off]