AMETEK M130 - Manual (Page 11)

Sorensen Ethernet Option Contents
M130/M131 Programming Manual v
3.9.1 STATUS SCPI Command Summary ................................................ 3-22
3.9.2 STATUS SCPI Command Reference ............................................... 3-22
3.10 SYSTEM SCPI Command Subsystem ......................................................... 3-24
3.10.1 SYSTEM SCPI Command Summary .............................................. 3-24
3.10.2 SYSTEM SCPI Command Reference ............................................. 3-25
3.11 TRIGGER SCPI Command Subsystem ........................................................ 3-29
3.11.1 TRIGGER SCPI Command Summary ............................................ 3-29
3.11.2 TRIGGER SCPI Command Reference ........................................... 3-29
3.12 Examples of Using the SCPI Commands ..................................................... 3-30
SECTION 4
CALIBRATION ............................................................ 4-1
4.1 Introduction .................................................................................................... 4-1
4.2 Setup for Calibration ...................................................................................... 4-2
4.3 Voltage Programming Calibration ................................................................... 4-3
4.4 Voltage Measurement/Readback Calibration ................................................. 4-5
4.5 Overvoltage Protection Programming ............................................................ 4-6
4.6 Current Programming Calibration ................................................................... 4-7
4.7 Current Measurement/Readback Calibration .................................................. 4-9
4.8 Update of Non-Volatile Calibration Dates ..................................................... 4-10
SECTION 5
OPERATION WITH M131 OPTION .............................. 5-1
5.1 Introduction .................................................................................................... 5-1
5.2 Configuration .................................................................................................. 5-1
5.3 System Installation ......................................................................................... 5-3
5.4 RS-485 Interface ............................................................................................ 5-4
5.5 Programming the M131 Unit (Example) ......................................................... 5-4
LIST OF FIGURES
Figure 2-1. Power Supply’s Home Page (DLM600 Series shown here) ....................... 2-2
Figure 2-2. Typical Rear Panel of M130 Ethernet Option for DLM600 ......................... 2-5
Figure 2-3. Typical Rear Panel of M130 Option for DCS1k and DCS1.2k .................... 2-5
Figure 2-4. Typical Rear Panel of M130 Option for DCS3k .......................................... 2-6
Figure 2-5. Typical Rear Panel of M131 Ethernet Option for DLM600 ......................... 2-6
Figure 2-6. Typical Rear Panel of M131 Ethernet Option for DCS1k and DCS1.2k ..... 2-6
Figure 2-7. Typical Rear Panel of M131 Ethernet Option for DCS3k ........................... 2-7
Figure 2-8. DLM 600W Configuration Switch for the M130 Option ............................... 2-8
Figure 2-9. DCS Configuration Switch for the M130 Option ......................................... 2-8
Figure 2-10. External User Connector Designation (8-pin Molex) .............................. 2-10