Aviosys 9211 User Manual
Page 23
To use the internal control function which we are going to introduce in
following page, please set all the pin on right switch to OFF and the light on DI
will be all off.
Please check the light status on DI board for the function it support:
We call “light turn ON” in DI board as “ LO”, and “light turn off “ in DI board as “ LF “.
1. As LO in either one each channel, 9211 will ask the setting IP
KAM
(9060A) take pictures.
User can also use the P5 area bottom of 9211 to control the LO.
As enable the function, as the DI status change, 9060 will take pictures.
User can also take pictures Hardware control. Set the Input as User can just press the bottom (=
P5) in 9211 to change status of any DI and the IP address of 9060 to do
Snap Shot.
23