Aviosys 9211 - Manual (Page 33)

Please refer following the NTP server IP address:
* 131.246.9.116
* 139.18.25.34
* 128.176.191.9
Note: To work NTP, please do set up in e-mail and have to receive e-mail from 9222.
6.9 Network Wakeup
Remote Wake up PC by MAC address in Ethernet (LAN)
Use Network port (RJ45), you can wake PC on WAN by PC `s MAC address.
Wake On LAN (WOL) premise:
(1) The main board needs to support “WOL“ function. There must be a port to connect to your network
card. If your Main board supports WOL ，you can enable this function in BIOS setting，you could
find this function in Power Management of BIOS setting.
(2) Your network card must support “WOL”, remember to connect your connect cable to Main board or
the network card can not send “power on” message to your main board.
After setup in main board and network card, you can use WOL function by following two-step:
Step 1: Log in 9222 web page and go to “Network Wakeup”
Step 2: Type in your MAC address then press “send ” – the PC will be power ON.
Note:
1. If the Network card is not onboard card, it needs to connect with your Main board by cable. Please
refer your network card connection
2. You can get your MAC address in PC, please refer following pictures:
Go to Network sign Status Support Details
Then the value in Physical Address “ is the PC` MAC address.
33