Flowserve URB 1 - Manual (Page 19)

19
Basic Settings
– continued –
Setting / changing node IDs of bus-based equipment
The standard default node ID setting of all
bus devices that can be displayed is “O
FF
”.
This setting acts as a wild card for all bus
devices which are not displayed with the
URB 1.
For each bus device that shall be displayed
by the URB 1 a node ID has to be
established manually.
We recommend to accept the factory set
node IDs of GESTRA bus devices. For the
relevant node ID setting please refer to the
corresponding installation manual of the
device.
Press button briefly to show the
address list and activate the
parameterisation mode.
Press button briefly to activate the line
selection mode.
briefly
briefly