Gasboy M06875K00X - Manual

MDE-4556 Gasboy ATC Kits M06875K00X Installation Manual • July 2006 Page 1
Introduction
This manual provides installation instructions for the Automatic Temperature Compensation
(ATC) Kits on Retail Atlas™ (8800K) units.
Note: Filters are required for installation but are not contained in the kits.
• M06875K001 for Single-Sided 8800K Unit
• M06875K002 for Two-Sided 8800K Unit
Contents
Required Reading
Before installing a kit, the installer must read, understand, and follow:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electrical Code
• Applicable Canadian, federal, state and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy Authorized Service Contractor (ASC) to ensure
warranty.
Section Page ...
Introduction 1
Required Reading 1
Required Tools 2
Abbreviations and Acronyms 2
Parts Lists 2
Important Safety Information 5
Installation 7
Preparing Site and Dispenser for ATC Option 7
Installing Filter Manifold and Probe 7
Installing the T-Meter Module and Cables 9
Installing I.S. Barrier Assembly 11
Installing ATC Controller Board 12
Connecting ISB Wires and Cable 15
Completing Installation 16
Programming the ATC Option 18
MDE-4556
Gasboy ATC Kits M06875K00X
Installation Manual
July 2006