Follows, Figure 3 – Gasboy M06875K00X User Manual
Page 10
Installation
Page 10
MDE-4556 Gasboy ATC Kits M06875K00X Installation Manual • July 2006
Figure 3: Cable Block Diagram for T-Meter Module
3
Route the T-Meter module cables using the following considerations:
• Place cables along bottom of hydraulic support rail to prevent damage from screws.
• Be careful to not damage cables when routing over brackets.
• Foam blocks will help to keep cables from falling during routing.
• Use Sealant, TPS or equivalent, to seal ends of any unused connectors to prevent damage
by moisture.
• Use up to four Q10178-03 cable ties to secure cables so connectors are located inside rail
away from moisture and cables do not have excessive slack.
• Adjust foam blocks into final position after cables and connectors are in place.
• All cables should be clear of moving components.
R20148-G3
R20147-G1
R20148-G3