Gasboy CFN Series Site Controller III Start-up - Manual (Page 85)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 79
Start-up Commands
13 – Start-up Commands
Some of the commands in this section use the; I option. This command option
should be used only at start-up. It initializes (erases) any data previously entered
for these commands. Subsequent use of these commands should omit the; I
option.
CAUTION
Use the following commands to set up the system at the initial start-up. Depending on the
particular configuration, some of these commands need not be performed. All commands are
covered in more detail in MDE-4762 Site Controller III Manager’s Manual for Windows XP
Embedded.
If you filled in the checklist in Section 2 of this manual, you already have the information you
need to start up the system. In all examples, bold represents the information that you enter, and
<RETURN> represents the RETURN key.
To show that it is ready to accept input, the SC displays a letter asterisk combination (P*). The
examples in this section all use the P* prompt.