Kemppi Pulse TCS User Manual
Page 11
EN
2.10 CONNECTING TO WELDING ROBOT
Select which one of the KempArc Pulse TCS power sources you want to make the leading
unit that controls the first filler wire. In this unit you should install the fieldbus card, which
connects the KempArc Pulse TCS system to the robot control unit.
It is recommended to install the fieldbus card to the same power source unit, which is
connected to the KempCool 40 cooling unit.
To install the fieldbus card, do the following:
1.
Open the cover of the black control unit box located above the power source.
2.
Install the fieldbus card onto the interface card as shown in the picture. Attach the fixing
nuts.
3.
Connect the welding robot's fieldbus cable to the fieldbus card's connector.
4.
Close the cover of the black control unit box.
Fieldbus cable connector
Fixing nuts
Fieldbus card
Interface card
9
KempA
rc P
ulse
TCS / © Kemppi O
y / 1204