Kemppi Pulse TCS - Manual (Page 5)

EN
1. INTRODUCTION
1.1 GENERAL
Congratulations on choosing the KempArc™ Pulse TCS welding equipment. Used correctly,
Kemppi products can significantly increase the productivity of your welding, and provide
years of economical service.
This operating manual contains important information on the use, maintenance and safety of
your Kemppi product. The technical specifications of the equipment can be found at the end
of the manual.
Please read the manual carefully before using the equipment for the first time. For your
own safety and that of your working environment, pay particular attention to the safety
instructions in the manual.
For more information on Kemppi products, contact Kemppi Oy, consult an authorised Kemppi
dealer, or visit the Kemppi web site at www.kemppi.com.
For Kemppi’s standard safety instructions and warranty terms and conditions, please visit our
web site at www.kemppi.com.
The specifications presented in this manual are subject to change without prior notice.
Important notes
Items in the manual that require particular attention in order to minimise damage and
personal harm are indicated with the ’NOTE!’ notation. Read these sections carefully and follow
their instructions.
Disclaimer
While every effort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specification of the product described at any time without
prior notice. Do not copy, record, reproduce or transmit the contents of this guide without
prior permission from Kemppi.
1.2 ABOUT KEMPARC PULSE TCS
KempArc Pulse TCS is a dual wire MIG/MAG welding system designed for demanding robotic
applications. It is equipped with a Tandem Control System (TCS), which means that it includes
two power sources and two control panels, both of them piloting independently their own
filler material feeds into the weld pool.
The system consists of two KempArc Pulse 450 A power souces, two DT 400 wire feeders,
one for the left side and one for the right side, and a welding gun with two contact tips. The
system has a liquid-cooling system managed by the KempCool 40 cooling unit.
With Kemppi's welding software products, such as modified processes and welding programs,
you can customize your KempArc Pulse TCS system to suit excactly your special welding
needs.
3
KempA
rc P
ulse
TCS / © Kemppi O
y / 1204