Kemppi Pulse TCS - Manual (Page 17)

EN
7. Menu display
8. Soft key buttons for menu selection
Use these buttons to select menu items. Their functions are determined by the selected menu
items.
3.4 MENU FUNCTIONS OF CONTROL PANEL K 60
3.4.1 Main menu functions
Value range Factory setting Description
Edit Channel for making changes to existing welding channel
Weld Data for checking out the values of the last weld
Special settings for adjusting special welding parameters
System Config Menu for device configuration and information
Language for selecting your menu language
Select Feeder (WF#) for selecting another parallel wire feeder as a
setup target
K 60 Robot menu list
Interface Version*
1 – 99 1 signal frame selection
Voltage Scaling 0 – 5000 0
WSF Scaling 0 – 5000 0
Current Scaling 0 – 5000 0
EM Stop Logic** 0 or 1 0
Door Switch On** 0 or 1 0
LimitFunctions Menu**
Current Tol 50 A not in use in interface version 1
Voltage Tol 5.0 V not in use in interface version 1
CurrentTolTime 1.0 s not in use in interface version 1
WSF Tol Time 1.0 s not in use in interface version 1
Gun Menu
Front Pull ON or OFF OFF
Test Menu
Wire Inch
1 – 20 m/min 1 m/min adjustment with the control knob
Gas Test press the button
* For more information, contact [email protected]
** Not in use in Interface version 1
15
KempA
rc P
ulse
TCS / © Kemppi O
y / 1204