Kemppi Pulse TCS - Manual (Page 20)

EN
3.4.3 Welding functions
OTHER PROCESSES (In Edit Channel menu 3/6)
HotStart ON, OFF or USER Factory setting is USER =>
USER can freely choose is the
HotStart ON or OFF
HOTStartLevel -50 ... +100 % 1 % steps. Factory setting 40 %
Hot 2T Time 0 – 9.9 s 0.1 s steps. Factory setting 1.2 s
CraterFill ON, OFF, USER Factory setting is USER =>
USER can freely choose is the
CraterFill ON or OFF
CraterStart 10 – 250 % Factory setting is 100% Set the level of the curve where the crater
filling will start
CraterFillEnd 10 – 250 %
lower than start 1 % steps. Factory setting 30% Set the level of the curve where the crater
filling will end.
CraterTime 0.0 – 10.0 s 0.1 s steps. Factory setting 1.0 s CrateFill Slope Time
Creep Start 10 – 99 % 1% steps. OFF, CURVE
(OFF = 100%) Factory setting is CURVE (Creep Start value
comes from Welding Curve).
StartPower -9 ... +9 Factory setting is 0 Adjusts arc ignition
WISEROOT / WISETHIN
HotStart ON, OFF or USER Factory setting is USER =>
USER can freely choose is the
HotStart ON or OFF
HOTStartLevel -50 ... +100 % 1 % steps. Factory setting 40 %
Hot 2T Time 0 – 9.9 s 0.1 s steps. Factory setting
1.2 s
CraterFill ON, OFF, USER Factory setting is USER =>
USER can freely choose is the
CraterFill ON or OFF
CraterStart 10 – 250 % Factory setting is 100% Set the level of the curve where the crater
filling will start.
CraterFillEnd 10 – 250 %
lower than start 1 % steps. Factory setting 30%
CraterTime 0.0 – 10.0 s 0.1 s steps. Factory setting
1. 0 s
Creep Start 10 – 99 % 1% steps. OFF, CURVE
(OFF = 100%) Factory setting is CURVE (Creep Start value
comes from Welding Curve).
18
KempA
rc P
ulse
TCS / © Kemppi O
y / 1204