Kreg DB55 Pneumatic Foreman Pocket-Hole Machine - Manual (Page 15)

R
DB55 Pneumatic - Adjustments 14.
Fig. 10A
Fig. 10B
Fig. 10C
Sockethead Cap Screws hold the EZ DB Fence
in position.
The FOREMAN ships from the factory with the Fence
in the 3/4” setting.
Move the Fence to the setting outlined for the
thickness of the material to be drilled.
Adjusting the EZ DB Fence Setting
The Fence can be adjusted to align the pocket hole to the center of
material of different thicknesses. When adjusting the Fence make sure
that the Fence remains perpendicular to the Guide Plate. A Reference Scale
has been provided to approximate the fence setting for 1/2”, 3/4”, and
1-1/2” thick material. These correspond to the “A”, “B”, and “C” lines on the
Reference Scale.
Step 1. Loosen the (2) Socket-head Cap Screws contained below the
surface of the Fence as shown in fig. 10A.
Step 2. Align the Fence perpendicular to the Guide Plate for the
setting that corresponds to the material thickness as
shown in fig. 10C.
Step 3. Tighten the (2) Socket-head Cap Screws to lock the Fence
into position as shown in fig 10A.
Reference Scale (shown in black to show detail)
A B C
A = 1/2” B = 3/4” C = 1-1/2”