LSC Lighting e24V3 - Manual (Page 15)

e24V3 Dimming System E24V3 QUICK TOUR
Operator Manual V3.0
LSC Lighting Systems (Aust) Pty. Ltd Page 11
Export Non-Patch Models have rear mount
connector panel with hard-wired output
connectors.
• 24 Double Shuko output connectors.
• 24 Double Shuko output connectors with
four 16-pole Harting connectors wired in
parallel.
• 24 Double Shuko output connectors with
four 19-pin Socapex connectors wired in
parallel.
• 24 Triple Swiss output connectors with
four 16-pole Harting connectors wired in
parallel.
• 24 Triple Swiss output connectors with
four 19-pin Socapex connectors wired in
parallel.
Non-Patch Output Connector options
3.8 Auxiliary Power Outlets
In addition to the 24 channels, all models are
fitted with 3 single phase auxiliary outputs, each
protected by its own Residual Current Device
(RCD).
Australian models have three 13 Amp Auxiliary
power circuits with Australian 3 pin sockets. On
Australian models fitted with two 3 phase input
connectors, supply to these three auxiliaries
comes from the second bank input connector.
Export “patch” models fitted with ST 18
connectors have 3 Auxiliary power circuits each
with one 16A CEEform connector and two ST18
sockets.
Export “patch” models fitted with GST 18
connectors have 3 Auxiliary power circuits each
with one 16A CEEform connector.
Export “non-patch” models fitted with Shuko
connectors have 3 Double Shuko auxiliary
power outlets.
Export “non-patch” models fitted with Triple
Swiss connectors have 3 Double Triple Swiss
auxiliary power outlets.