Marantz SR6008 - Manual (Page 184)

184
Appendix Tips Playback Connections Contents
Front panel Display Rear panel Index Remote
Settings
2 Lch Level
Adjust the left channel output level.
–12dB – +12dB (Default : 0dB)
2 Rch Level
Adjust the right channel output level.
–12dB – +12dB (Default : 0dB)
2 Channel
Set the signal output from multi-zone.
Stereo (Default) : Select stereo output.
Mono : Select monaural output.
2 HDMI Audio
Selects the audio signal format for playing an HDMI source in ZONE2.
Through (Default) : The HDMI audio signal is passed through the AV
receiver to the device in ZONE2.
PCM : The HDMI audio signal is converted to PCM format so you
can listen to HDMI sound from the ZONE2 pre out or ZONE2
assigned speakers.
2 Volume Level
Set the volume output level.
Variable (Default) : Volume adjustment is enabled by main unit and
remote control unit.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
2 Volume Limit
Make a setting for maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB) (Default : 70 (–10dB))
Off : Do not set a maximum volume.
2 Power On Volume
Define the volume setting that is active when the power is turned on.
Last (Default) : Use the memorized setting from the last session.
Mute : Always mute when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
2 Mute Level
Set the amount of attenuation when muting is on.
Full (Default) : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
%
• This can be set when “Volume Level” is set to “Variable”.