Marantz SR6008 - Manual (Page 199)

199
Appendix Settings Playback Connections Contents
Front panel Display Rear panel Index Remote
Tips
Symptom Cause/Solution Page
DTS sound is not output. • Check that the digital audio output setting on the connected device is set to “DTS”.
• Set “Decode Mode” on the menu to “Auto” or “DTS”.
–
163
Dolby TrueHD, DTS-HD, Dolby Digital
Plus audio is not output.
• Make HDMI connections.
• Check the digital audio output setting on the connected device. On some devices, “PCM” is
set by default.
37, 38
–
Dolby PLg mode or DTS NEO:X mode
cannot be selected.
• It cannot be selected when “None” is set for “Speaker Config.” – “Center” and “Surround”.
• These cannot be selected when using the headphones.
174
–
Audyssey MultEQ® XT, Audyssey
Dynamic EQ® and Audyssey Dynamic
Volume® cannot be selected.
• These cannot be selected when you have not performed Audyssey® Setup.
• Switch the sound mode to other than “DIRECT” or “PURE DIRECT”.
• These cannot be selected when using the headphones.
• These cannot be selected when an HD audio format with a sampling frequency of over 96 kHz
is input (such as may be found on select Dolby TrueHD and DTS-HD discs).
164
110
–
–
Audyssey DSX® cannot be selected. • It can be selected when using the front height or front wide speakers.
• It can be selected when using the center speaker.
• Switch the sound mode to DOLBY sound mode or DTS sound mode.
• This cannot be selected when using the headphones.
• This cannot be selected when an HD audio format with a sampling frequency of over 96 kHz
is input (such as may be found on select Dolby TrueHD and DTS-HD discs).
175
174
109
–
–
“M-DAX” cannot be selected. • Check that an analog signal or PCM signal (Sample Rate=44.1/48 kHz) is input. For playback
of multichannel signals such as Dolby Digital or DTS surround, “M-DAX” cannot be used.
• Switch the sound mode to other than “DIRECT” or “PURE DIRECT”.
148
110