NavCom StarFire Satellite Change Rev.I - Manual (Page 14)

Troubleshooting Guide – StarFire™ Satellite Changes
Rev. I xiv Release - June 15
SF-2110 – All versions
Please follow the procedure below to manually tune the StarFire receiver to the new frequency for the satellite
located at 25.5° East. This instruction applies to SF-2110, all versions.
This instruction assumes that the receiver is currently licensed for and tracking StarFire satellite signals. If
after completing this instruction, the receiver is not tracking StarFire signals, please refer to the
StarFire
Tracking Troubleshooting Guide .
 View → AE – Version Information
 Select Receiver → Messages → NCT output from the
menu bar. The NCT Binary Messages window opens.
o Ensure that these messages are scheduled for
output:
 86 – On Change
 A0 – On Change
 AE – Every 600 Seconds
 B1 – On Change
 D1 – Every 600 Seconds
 D3 – On Change
 DB – Every 600 Seconds