NavCom StarFire Satellite Change Rev.I User Manual
Page 5
Troubleshooting Guide
– StarFire™ Satellite Changes
Rev. I
v
Release - June 15
o LBM Software v1.5 or Earlier and GPS Software Version 3.1.17 or Earlier
LBM DSP Status
Check StarFire signal C/No Value which should be above 0dB (>9dB is typical at
NavCom’s office in Southern California)
The C/No value varies based on the distance between the StarFire satellite and the receiver.
Set the Alternate Satellite
o Select Receiver
→ Setup → StarFire →Alternate Channel
o Set the Alternate Channel to based on the Table 3 below
Table 3: Satellite
ID’s and Channel No’s for New Satellites
Location Net
Satellite ID
Channel No
Frequency (KHz)
New Service on-air
54W
2
446
41955
1,545,977.5
11/1/2014
15.5W
2
484
41975
1,545,987.5
11/1/2014
64E
2
564
41935
1,545,967.5
11/1/2014
178E
2
678
41975
1,545,987.5
11/1/2014
98W
1
402
41935
1,545,967.5
06/12/2015
25E
1
525
41770
1,545,885.0
06/12/2015
143.5E
1
643
41955
1,545,977.5
06/12/2015