NavCom StarFire Satellite Change Rev.I - Manual (Page 19)

Troubleshooting Guide – StarFire™ Satellite Changes
Rev. I xix Release - June 15
Sapphire, SF-3040, and SF-3050 – All versions
Please follow the procedure below to manually tune the StarFire receiver to the new frequency. This
instruction applies to Sapphire, SF-3040, and SF-3050 all software versions.
This instruction assumes that receiver is currently optioned and licensed for and tracking StarFire satellite
signals. If after completing this instruction, the receiver is not tracking StarFire signals, please contact
NavCom Customer Support .
 Detailed Views → Firmware Info
o If the Navigation version number is lower than 03.05.XX, perform the following steps which
follow