NavCom StarFire Satellite Change Rev.I User Manual
Page 6
Advertising
Troubleshooting Guide
– StarFire™ Satellite Changes
Rev. I
vi
Release - June 15
o Check Use Alternate Channel
o Check Ack/Nak
o Click OK
View → D3
o After a few minutes, the receiver should be tracking the new StarFire Satellite
LBM DSP Status
Check SF Channel Number (see Table 3 above)
Check StarFire signal C/No Value which should be above 0dB (>9dB is typical at
NavCom’s office in Southern California)
If the receiver is moved from one StarFire region to another, the receiver will not automaticly tune to
the new receiver frequency. When this occurs, repeat the initial steps with the appropriate new
Channel ID.
Advertising