NavCom StarFire Satellite Change Rev.I - Manual (Page 15)

Troubleshooting Guide – StarFire™ Satellite Changes
Rev. I xv Release - June 15
 View → D3
 LBD DSP Status
 Check StarFire signal C/No Value which should be above 0dB (>9dB is typical at
NavCom’s office in Southern California)
The C/No value varies based on the distance between the StarFire satellite and the receiver.
 Define Satellite
o Select Receiver → Setup → StarFire →Define Satellite
o Check Enter User-Defined Satellite
o Set the Frequency(KHz) to Satellite ID per Table 3 for the appropriate area of operation