NavCom StarFire Satellite Change Rev.I - Manual (Page 4)

Troubleshooting Guide – StarFire™ Satellite Changes
Rev. I iv Release - June 15
 Select Receiver → Messages → NCT output from the menu bar. The NCT Binary Messages window
opens.
o Ensure that these default messages are scheduled for output:
 86 – On Change
 A0 – On Change
 AE – Every 600 Seconds
 B1 – On Change
o Schedule this message for output:
 30 – On Change
 Schedule messages for output that are pertinent to the
StarFire L-Band Module (LBM).
o Select Receiver → Setup → StarFire →
Configure Message Output. The LBM
Messages window opens.
o Schedule these messages for output:
 D0 – Every 600 Seconds
 D1 – Every 600 Seconds
 D2 – On Change
 D3 – On Change
 D5 – On Change
 View → D3