NavCom StarFire Satellite Change Rev.I User Manual
Page 17
Advertising
Troubleshooting Guide
– StarFire™ Satellite Changes
Rev. I
xvii
Release - June 15
View → D3
o After a few minutes, the receiver should be tracking the new StarFire Satellite
LBD DSP Status
Check SF Satellite ID (refer to Table 3)
Check StarFire signal C/No Value which should be above 0dB (>9dB is typical at
NavCom’s office in Southern California)
If the receiver is moved from one StarFire region to another, the receiver will not automaticly tune to
the new receiver frequency. When this occurs, repeat the initial steps with the appropriate new
frequency and ID.
Advertising