NavCom StarFire Satellite Change Rev.I - Manual (Page 22)

Troubleshooting Guide – StarFire™ Satellite Changes
Rev. I xxii Release - June 15
 Set the Alternate Satellite
o Select Receiver → Setup → StarFire →Alternate Channel
o Set the Alternate Channel to the appropriate Satellite ID as shown in Table 3 above
o Click the Refresh button
o After a few minutes, the receiver should be tracking the new StarFire Satellite
 Check SF Satellite ID (refer to Table 3 for proper Satellite ID)
 Check StarFire signal C/No Value which should be above 0dB (>9dB is typical at
NavCom’s office in Southern California)

If the receiver is moved from one StarFire region to another, the receiver will not automaticly tune to
the new receiver frequency. When this occurs, repeat the initial steps with the appropriate new
frequency and ID.

Observe the operational mode and correction age
o dGPS mode: StarFire Dual RTG or StarFire Dual GNSS
This coverage map shows the coverage after all frequencies are changed: