Nortec SE Series - Manual (Page 52)

49 | Operation
SETC Humidifier Configuration
Navigating the SETC Software
The four input buttons below the digital display are used to navigate in the SETC’s software and
to enter values. The function of the four buttons changes depending on what is being displayed
on the screen. In all cases 4 icons representing the functions of the buttons are shown at the
bottom of the screen.
Figure 45: Navigating the SETC Software
Main Menu (SETC Password)
The menu levels of the SETC are password protected to prevent configuration changes by
unauthorized persons. In order to access the menu level press the button corresponding to the
Menu icon and when prompted enter the password 0335.
Enter Password
Press the Menu button from any
status screen. Enter the user level
code 0335 using the up arrow to
change the value of each digit and
the right arrow to move to the next
digit. Press the Set button.
Main Menu
From here you can access all user
configurable settings. Select any
sub-menu by using the up/down
arrow buttons and pressing Set
when the desired one is
highlighted.
Note: Do not make changes unless
you are familiar with the software.
Password
0335
Enter Code
Confirm with Set
Menu Set
Request – 100%
Idle 30 lb/hr
04/30/09 14:25:22
Security loop: Closed
Menu ?
Main Menu
Service Level
User Defined Settings
Control Settings
Diagnostics
Menu Set
5
Service Level
Request – 100%
Idle 150 lb/hr
04/30/09 14:25:22
Security loop : Closed
Menu ?
Set P
45%
45 %
ESC Set
45%
Screen Displays Screen Displays
Press to go
down a
menu level
Press to
go left
/right one
screen
?=Press for
information
about current
warning or fault
message
Press to go
up a menu
level
Press to
increase/
decrease
value
Press to
accept
setting and
go up a
level