Orion System PT-Link II BACnet2 - Manual (Page 13)

PT-Link II Interface
PT-Link II BACnet ® Technical Guide
13
17.) At the next screen, (Figure 22), type
<D>
again.
15.) Once the changes are made to the text fi le, click
<File>
in the
upper left and then click <Save> . Now close the fi le and return to
the RUINET Main Menu.
16.) From the RUINET Main Menu, type <D> to Download the new
confi g.csv fi le to the FieldServer (Figure 21).
Figure 21: Download new Confi g.csv fi le
Figure 22: Download new Confi g.csv fi le
NOTE: The utility will indicate when downloading is
complete. DO NOT reset the PT-Link until this mes-
sage is displayed, as this will corrupt the PT-Link.
NOTE: The Remote Filename option must always be named
“confi g.csv” for confi gurations; otherwise, it will be
ignored by the PT-Link.
18.) Once the download is complete, restart the PT-Link II by
cycling power or press
<Esc> to get back to the RUINET Main Menu
and then type <!> option to save the new confi guration fi le and restart
RUINET. It is possible to do multiple downloads to the PT-Link II
before resetting it. There will be a start-up period where you will be
unable to connect to the PT Link.
19.) From the RUINET Main Menu, type
<A>
for the Data Array
Overview. The Data Array Overview Screen will display (Figure 23).
Verifying PT-Link Communications
Figure 23: Data Array Overview Screen
20.) This screen (Figure 23) will verify communication to the HVAC
units. Lines 1 & 2 should always be present. After a start-up period
of approximately 4 minutes, you will see 1 additional line for each
HVAC unit. This screen represents the PT Link II communicating
with 1 HVAC unit.
21.) Once these steps have been completed and you have verifi ed
that the reconfi gured PT Link II has established communication to the
HVAC unit(s), it can now be added to the BAS network.