Quintum Technologies Tenor Call Relay 60 - Manual (Page 20)

P/N 480-0076-00-00 2-2
Chapter 2: Hardware Components
Hardware Description
Call Relay 60 is a stackable/rack mountable device which provides connections to two different
sites: Ethernet LAN and a PC.
Front Panel Connections and Reset/Diag Options
Figure 2-1 Front
LAN1/LAN2
Reset
Diag Console Port
View
Reset. Resets the entire unit.
Diag. Enables you to perform software diagnostic procedures.
LAN 1/LAN 2 10/100 Base-T Ethernet ports. LAN 1 port provides an RJ-45 jack for an individual
connection to a 10/100 Ethernet LAN switch or hub via RJ-45 cable; it is individually configured
with a unique IP and MAC address. LAN 2 Ethernet port is reserved for future use.
Figure 2-2 10/100 BASE-T Ethernet Port Pin Order
Table 2-1 Input/Output 10/100 Ethernet port
Pin # Signal Definition
1 TX + Transmit Data
2 TX - Transmit Data
3 RX + Receive Data
4 RSVD Reserved