Assign ip address, Assign ip address -10, Tion – Quintum Technologies Tenor Call Relay 60 User Manual
Page 37: Assign, Ip address
P/N480-0076-00-00
3-10
Chapter 3: Installation
Assign IP Address
Before you can configure Call Relay 60, you need to assign a valid IP address. An IP address is a 32
bit (up to 12 numeric characters) address used to identify each network device in the TCP/IP net-
work.
Assign IP address as follows:
1. Click on Start> Programs> Accessories> Communications> HyperTerminal> Run. The Hyper-
Terminal window will be displayed.
2. Click on Hyperterm.
3. Enter a Connection Description (i.e., name for each unit such as CR60 NJ).
4. Click Ok.
5. Choose the connection port on your PC from the Connect Using drop down list box (i.e., Direct
to Com 1). Click Ok. The Com1 Properties window will be displayed. See
.
Figure 3-7 Port Settings Window
6. From the Bits Per Second drop down list box, choose 38400.
7. From the Data Bits drop down list box, choose 8.
8. From the Parity drop down list box, choose None.
9. From the Stop bits drop down list box, choose 1.
10.From the Flow control drop down list box, choose None.
11.Click on Ok.