Quintum Technologies Tenor Call Relay 60 - Manual (Page 36)

P/N 480-0076-00-00 3-9
Chapter 3: Installation
Power up the System
Once you have all cables connected properly, you are ready to turn the system on as follows:
1. Plug in the power cord to an AC outlet.
2. Locate the on/off switch on the back of the unit and click the switch to On.
The unit will power up and the LEDs will flash and turn off; the power LED will remain lit. For
information about the LEDs, see
Chapter 2: Hardware Components .
Once the unit is powered up, you are ready to assign an IP address. See the following section Assign
IP Address .