Quintum Technologies Tenor Call Relay 60 User Manual
Page 42
P/N 480-0076-00-00
4-4
Chapter 4: Getting Started with Configuration
routing information. In addition, you are also able to monitor system alarms and run diagnostic pro-
cedures. CLI attributes enable you to further configure CLI options; these provide additional config-
uration items according to the option type.
Through the CLI, there are also commands you execute to simplify the process of configuring and
monitoring the Call Relay 60 unit. Some of these commands are globally used, others are specific to
the mode in which you are working. For example, the set command, available globally from within
the Configuration mode, enables you to set attributes for different options.
You can access the CLI through a Telnet session, a terminal-like access to any Call Relay 60 unit. If
your PC is directly connected to the Call Relay 60 unit, you can configure the unit directly through
the serial port using HyperTerminal. Both methods are described below.
NOTE:
Alternatively, you may want to use other telnet clients, such as the Linux telnet client or
free programs like Putty. If you choose to do so, you may have to make minor setting
changes in the Telnet client in order to make it function properly.
Telnet Connection. Once the Call Relay 60 has been initially configured with an IP address net-
work and is connected, the easiest way to connect to the unit and use the CLI is through a standard
Telnet session from any PC on your IP network. Connect to a Call Relay 60 unit via Telnet as fol-
lows:
For Windows 95/Windows 98:
1. Click on Start> Run. The Run dialog box will be displayed.
2. Type telnet and click on Ok.
3. Click on Connect> Remote System.
4. In the Host Name field type, enter the IP address assigned to your Call Relay 60.
5. Click on Connect.
A connection to the Call Relay 60 unit will be established.
For Windows 2000 and above:
1. Click on Start> Run.
2. The Run dialog box will be displayed. Type telnet and click on Ok. (Or type telnet followed by
the IP address and you will connect.)
3. At the telnet prompt, type open (followed by the IP address for the unit to which you want to
connect.)
A connection to the Call Relay 60 unit will be established.
Serial Port Connection. When the Call Relay 60 is first shipped to you, you must connect to the
unit using this method to assign an IP address. Once this is assigned, you can use the CLI to reach