Quintum Technologies Tenor Call Relay 60 - Manual (Page 33)

P/N480-0076-00-00 3-6
Chapter 3: Installation
Connection
Connect to Ethernet LAN
You can use these instructions for general connection purposes only. The Ethernet hub/switch manu-
facturer’s documentation should provide specific instructions for connection to another device, such
as the Call Relay 60. Only LAN 1 is available for use; LAN 2 is reserved for future use.
Figure 3-4
Data
Network
Ethernet Hub/Switch
Connect to Ethernet Hub/Switch
1. Plug one end of the grey or white RJ-45 Ethernet cable into the port labeled LAN 1.
2. Plug the other end of the cable into one of the Ethernet hub/switch ports. If a custom cable or
adapter is required, see Chapter 2: Hardware Components for Ethernet RJ-45 10/100.