Verilink HDM 2182 (880-502925-001) Product Manual - Manual (Page 25)

Standalone HDM 2182 Management
Verilink HDM 2182 User Manual 3-3
Although Table 3-1 above presents application management
options in the order as they appear on the Main Menu, this manual
discusses the options in the order that the options will be needed
during initial set-up of the module.
Administration Menu
When you access the HDM 2182 for the first time after installation,
various parameters must be set for the module to operate properly.
Parameters such as the node address, site name, date/time, IP
parameters, and firmware download are set in the node’s
Administration Menu. For information about IP addresses, check
with your system administrator.
Type the command O from the Craft Interface Menu
O) node administration
to display the Administration Menu.
W Change Craft Password—displays field used to change Craft password as follows:
HDM > w HDM > w HDM > w HDM > w
Old Password:
Old Password: Old Password: Old Password:
New Password (4-20 chars):
New Password (4-20 chars): New Password (4-20 chars): New Password (4-20 chars):
Type New Password again:
Type New Password again: Type New Password again: Type New Password again:
Password Changed.
Password Changed. Password Changed. Password Changed.
T Change Craft Timeout Length—displays menu from which one can change the Craft timeout
period as follows:
HDM > t HDM > t HDM > t HDM > t
The current timeout length: 15 mins. Change (Y/N)? y
The current timeout length: 15 mins. Change (Y/N)? y The current timeout length: 15 mins. Change (Y/N)? y The current timeout length: 15 mins. Change (Y/N)? y
Please enter new timeout length (5 - 30 min): 15
Please enter new timeout length (5 - 30 min): 15 Please enter new timeout length (5 - 30 min): 15 Please enter new timeout length (5 - 30 min): 15
Timeout length is changed.
Timeout length is changed. Timeout length is changed. Timeout length is changed.
X System Log-off—Logs you out of the HDM access.
Command Description