Verilink HDM 2182 (880-502925-001) Product Manual - Manual (Page 49)

Verilink HDM 2182 User Manual 4-1
Chapter
4
HDM 2182 Management: Using NCM
2000
ASCII Access Settings
To access an HDM 2182 on the node from an ASCII terminal
connected to the Local port on an NCM 2000:
1. Ensure that your terminal parameters are set to the following
values:
• 19.2 kbit/s
• 8 data bits
• no parity
• one stop-bit
• no flow-control
Be sure that
X- ON
/
X- OFF
flow control is disabled.
2. Type “craft” and press E NTER .
3. At the PASSWORD: PASSWORD: PASSWORD: PASSWORD: prompt, press E
NTER .
Until you change the password, the E NTER key is the default
password. If you have changed the password or have been assigned
a password, type the correct password (up to 8 characters,
including spaces). The screen will display placeholders (
******
) as
you type the password. After typing the password, press E NTER .
The password of the NCM 2000 determines the level of access
available with the various functions of the HDM 2182. See the NCM
2000 User Manual for more information about this security feature.