Document Outline

• Front Matter
  • Copyright Notice
  • Trademarks
  • Acknowledgment
  • FCCRequirements
  • Canadian Emissions Requirements
  • Warranty
  • Customer Service
  • Returning Products
  • Safety Precautions
• About This Guide
  • What is a Reference Manual?
  • Where to go for information
  • Conventions
• 1. General
  • Introduction
  • Features
  • Specifications
    • Network Interface
    • Equipment Interface
    • Management Interfaces
    • MIBS
    • Diagnostics
    • Alarms
    • Power
    • Mechanical
    • Environmental
    • Compatibility
    • Industry Listings
• 2. Installation
  • Unpacking and Inspection
  • Supplied Materials
  • Rack Mounting
  • Front Panel Port Connections
    • Local Access
    • Monitor
  • Rear Panel Port Connections
    • Network
    • DTE
    • Network Management
    • Control Switch
      • S1-1
      • S1-2
      • S1-3
      • S1-4
    • AC Power
    • Ground Stud
• 3. Front Panel Interface
  • Power
  • Test
  • DTE Clock Loss
  • BPV
  • PAR ERR
  • REM PAR ERR
  • TX YEL
  • TX AIS
  • LOSS SIG
  • LOSS FRM
  • RX YEL
  • RX AIS
• 4. Terminal Interface
  • Modem Compatibility
  • Interface Start-up
  • Configuration Commands
    • Set Commands
      • SET NET LBO
      • SET NET YELLOW-X-BIT
      • SET NET AIS PATTERN
      • SET NET AIS RX-STUFFING
      • SET NET AIS TX-XBIT
      • SET DTE RATE
      • SET DTE CA
      • SET DSU
      • SET MAP
      • SET SUPERVISORY MODE
      • SET SUPERVISORY BAUD
      • SET SUPERVISORY COA
      • SET SUPERVISORY DIAL-STRING
      • SET SUPERVISORY HANGUP-STRING
      • SET SUPERVISORY INIT-STRING
      • SET SLIP
      • SET SLIP MODE
      • SET SLIP BAUD
      • SET SLIP DIAL-STRING
      • SET SLIP HANGUP-STRING
      • SET SLIP INIT-STRING
      • SET SLIP FILTER
      • SET SLIP UNIT-ADDRESS
      • SET SLIP SUBNET-MASK
      • SET SLIP ROUTER-ADDRESS
      • SET SNMP READ-COMMUNITY
      • SET SNMP WRITE-COMMUNITY
      • SET SNMP TRAP
      • SET SNMP SYSTEM
      • SET SCRAMBLER
      • SET PROGRAM EPROM
      • SET PROGRAM EPROM
      • SET ADMINISTRATION PASSWORD {password} NAME {name} LEVEL {1,2,3}
      • SET ADMINISTRATION PASSWORD {password} DELETE
      • SET ADMINISTRATION PASSWORD {password} CHANGE
      • SET ADMINISTRATION TOD
      • SET ADMINISTRATION UNITID
      • SET ADMINISTRATION CIRCUIT
      • SET ADMINISTRATION APPLICATION
      • SET AUDIBLE
      • SET DATALINK EIC
      • SET DATALINK LIC
      • SET DATALINK FIC
      • SET DATALINK UIC
      • SET DATALINK PATH-MESSAGE
      • SET DATALINK IDLE-MESSAGE
      • SET DATALINK TEST-MESSAGE
      • SET DATALINK TERMINAL DTE
      • SET DATALINK TERMINAL CARRIER
    • Get Commands
      • GET NET
      • GET DTE
      • GET SUPERVISORY
      • GET SLIP
      • GET SNMP
      • GET MAP
      • GET STATUS
      • GET SCRAMBLER
      • GET PROGRAM
      • GET ADMINISTRATION
      • GET AUDIBLE
      • GET DATALINK
        • Equipment ID Code
        • Location ID Code
        • Frame ID Code
        • Unit
        • Path ID Message
        • Idle Signal ID Message
        • Test Signal ID Message
        • Terminal Type
      • GET FAR DATALINK
        • Equipment ID Code
        • Location ID Code
        • Frame ID Code
        • Unit
        • Path ID Message
        • Idle Signal ID Message
        • Test Signal ID Message
        • Terminal Type
    • Query Commands
      • QUERY ALARMS
      • QUERY LOOP
      • QUERY PERFORMANCE EFS
      • QUERY PERFORMANCE ES
        • Errored Seconds - Type A (ES-A)
        • Errored Seconds - Type B (ES-B)
        • Errored Seconds - Type C (ES-C)
      • QUERY PERFORMANCE SES
      • QUERY PERFORMANCE SFE
      • Display Formats
    • Test Commands
      • TEST LOOP LOCAL DTE SET
      • TEST LOOP LOCAL DTE CLEAR
      • TEST LOOP LOCAL LINE SET
      • TEST LOOP LOCAL LINE CLEAR
      • TEST LOOP REMOTE SET
      • TEST LOOP REMOTE CLEAR
      • TEST LOOP REMOTE REQUEST
      • TEST LOOP REMOTE END
      • TEST SYSTEM
    • Reset Commands
      • RESET ALARMS
      • RESET PERFORMANCE
    • Reboot Commands
      • REBOOT COLD
      • REBOOT WARM
• Appd. A. MIB Reference
  • MIB Loading Instructions
  • RFC 1407 MIB
    • dsx3ConfigTable
    • dsx3FarEndConfig
    • dsx3FracTable
  • PRISM 3301 MIB
    • t3NetTable
    • t3DatalinkConfig
    • t3DteConfig
    • t3CurrentConfig
    • t3IntervalConfig
    • t3TotalConfig
  • TXPORT MIB
    • companyInfo
    • productInfo
  • Definition of Traps
  • Enterprise Specific Traps
• Appd. B. Ordering Information and Optional Equipment
  • Ordering Information
  • Optional Equipment