Verilink QUAD DATA (880-503319-001) Product Manual - Manual (Page 26)

Configuration
3-2 Verilink QUAD DATA User Manual
Your computer may have a DB-9 connector for the COM port,
requiring a second cable or adapter to complete the connection. For
this purpose, use the same type of standard PC AT serial cable as
would be used to connect to an external modem.
The current Craft cable uses DB-9 and RJ-11 connectors,
eliminating the need for a second cable when the COM port of a PC
is used. It is wired according to the pinout shown in
Table 3-2 :
Table 3-2 DB-9 Craft Cable P/N 458-102119-008
Log In The first thing displayed after connecting a terminal and pressing
the E
NTER key is:
pSH+> pSH+> pSH+> pSH+>
Certain TCP/IP and UNIX commands are available from this prompt
(ping, FTP, mv, rm, ls).
Most often you will want to use the Craft interface. To reach the
Craft interface from the
pSH+> pSH+> pSH+> pSH+> prompt, type the word “craft” in
lowercase:
pSH+> pSH+> pSH+> pSH+> craft
The password prompt appears:
YOUR PASSWORD? YOUR PASSWORD? YOUR PASSWORD? YOUR PASSWORD?
Initially there is no password, so just press E
NTER again.
The SCM Main Menu is displayed, as shown in Figure 3-1 .
DB-9 female RJ-11 modular Usage
pin 3 pin 3 Transmit Data
pin 2 pin 4 Receive Data
pin 5 pin 5 Signal Ground