WattMaster WCC II - Manual (Page 189)

Section 4: Remote Communications
WCC II Operator’s Guide
Operator Interfaces 4-1
SECTION 4: REMOTE
COMMUNICATIONS
____________________________________________________
GENERAL INSTRUCTIONS
You can view the screens of an existing ECC/WCC II system and/or
make data entries from a computer located at a remote site. Remote
read and reset of ECC/WCC II setpoints can be accomplished by
using a remote computer to communicate with the ECC/WCC II
system over standard telephone lines. The system at the building is
called the ECC/WCC II, and the remote system is referred to as the
FCC/SCC II ( Facilities Control Center/Service Control Center).
You can communicate with the ECC/WCC II “live.” That is to
say, while using the remote computer, you can change setpoints
immediately, and you can watch a measured variable such as
temperature change. You can think of the remote computer as being
an additional monitor (screen) and keyboard which is connected to
the ECC/WCC II computer. An operator at the building may be
making data entries or changes using the local Operator Control
Console at the same time you are making data entries using the
remote computer.
The FCC/SCC II software is used in the remote computer. This
software will allow the remote computer to perform nearly all of
the functions that the ECC/WCC II can.
Notes: