ATL Telecom R1-SW Ethernet Switch User Manual
Page 164
R1-SW24L2B User’s Manual
8-30
[alarm]
index status
sample
----- -------------- -----------------------------
1
valid
etherStatsPkts.1
[event]
index status type
----- -------------- ---------------
10
valid
logandtrap
.
.
#
Before configure RMON alarm group, you should verify that the statistics group
(<StatisticsIndex>) is defined. If you specify undefined statistics group, the ‘Can't fetch
the MIB values
’ message will be displayed:
(config)# rmon alarm 2 20 pkts 10 absolute rising threshold 1000 100 event-
index 1 1 owner kimka
Can't fetch the MIB values
(config)#
To display the detail information on an alarm group, enter the show rmon alarm command
with the alarm number:
# show rmon alarm 1
Alarm 1 is valid, owned by aaa
Monitors etherStatsEntry.etherStatsPkts.1 every 10 seconds
Taking absolute samples, last value was 0
Rising threshold is 1000, assigned to event 1
Falling threshold is 100, assigned to event 1
On startup enable rising or falling alarm
#
To delete a RMON alarm group, enter the no rmon alarm command in Global configuration
mode:
(config)# no rmon alarm 1
(config)#