Lacp configuration example, Switch a, Switch b – ATL Telecom R1-SW Ethernet Switch User Manual
Page 257
Configuring LACP
12-9
LACP Configuration Example
The following link aggregation configuration example configures a link aggregation between
two Corecess R1-SW24L2Bs.
Switch A
The following shows how to configure link aggregation on the switch A:
Switch A # configure terminal
Switch A(config)# lacp key 33 port fastethernet 2/1-4 mode active
Switch A(config)# end
Switch A# write memory
Building Configuration...
[OK]
Switch B
The following shows how to configure link aggregation on the switch B:
Switch B# configure terminal
Switch B(config)# lacp key 33 port fastethernet 2/1-4 mode passive
Switch B(config)# end
Switch B# write memory
Building Configuration...
[OK]
Trunk group
y
Port : 2/1-4 on Switch A
2/1-4 on Switch B
y
LACP admin key : 33
Switch A
Switch B
Active <-----> Passive