ATL Telecom R1-SW Ethernet Switch - Manual (Page 268)

R1-SW24L2B User’s Manual
13-10
LAN ID: 1
Protocol Operation: enabled
Root Bridge: yes
STP version: stpCompatible(0)
Pathcost Encoding: 32bit
BridgeID: 0x8000-00905ACC0201
Time since topology change: 2453(s)
.
.
.
#
Disable STP only if you are sure there are no loops in the network topology . When STP is
disabled and loops are present in the topology, excessive traffic and indefinite packet
duplication can drastically reduce network performance. To disable STP on a per-VLAN basis,
enter the no stp vlan command in Global configuration mode. The following example
shows how to disable STP on the VLAN whose ID is 1:
(config)# no stp vlan id 1
(config)#
If you disable STP on a VLAN, STP is disabled on all ports belongs to the VLAN.