Grass Valley K2 Summit 3G v.9.0 - Manual (Page 49)

About networking
When you receive a K2 Summit 3G system from the factory, it has a specific network configuration,
including a loopback adapter and two of the four Gigabit Ethernet ports configured as a teamed pair.
The Gigabit Ethernet ports, as viewed when looking at the rear panel, are represented in the following
illustration.
1
2 3
4
Control Team: Same for internal, direct-
connect, and SAN storage.
iSCSI:
SAN
storage iSCSI:
Redundant
SAN stor-
age
Control:
Internal,
direct-
connect,
and SAN
storage Control:
Redundant
SAN stor-
age
FTP/Streaming:
Internal and
direct-connect stor-
age
Media
Connection #1
Control
Connection #1
Control
Connection #2
Media
Connection #2
Restoring network configuration
When you restore a system from its system specific image, network configuration is also restored
to the factory default settings. This is the recommended method of restoring network configuration.
However, if for some other reason you must configure network settings manually, use the tasks in
this section to restore the default network configuration.
Create the Control Team
NOTE: Team control ports only. Do not team media ports.
1. Open Network Connections, if it is not already open.
14 November 2012 K2 Summit 3G Service Manual 49
Service procedures