Grass Valley K2 Summit 3G v.9.0 - Manual (Page 95)

Disk controller board removal
Before doing this task, remove the front bezel assembly.
1. To remove the disk controller board, proceed as illustrated.
Remove screw 1
Slide out 2
2. When installing, do the following:
a) Make sure the board engages with the top and bottom guides.
b) Make sure the board engages with the connectors on the disk backplane and midplane board.
After replacing the disk controller board on a K2 Summit 3G system or on any system that has a
Type II (ADLINK) CPU carrier module, you must restore disk controller configuration. This includes
the first generation K2 Summit system, which can have a Type II CPU carrier module that was
installed in the factory or that was upgraded in the field.
Related Topics
Restoring disk controller configuration on page 58
14 November 2012 K2 Summit 3G Service Manual 95
Removing and replacing FRUs