Grass Valley K2 Summit 3G v.9.0 - Manual (Page 72)

Installing the ATTO Fibre Channel card driver
If the K2 Summit 3G system is on a redundant K2 SAN or is connected to direct-connect storage,
make sure that MPIO software is installed.
If your K2 Summit 3G system has the optional Fibre Channel card, the driver for the Fibre Channel
card is not installed on the recovery image provided by Grass Valley for that K2 Summit 3G system.
Therefore, after restoring the image, you must install the Fibre Channel card driver.
1. Open Device Manager.
2. Right-click on K2 Summit Client and select Manage.
3. Click Device Manager
4. Install the first Fibre Channel driver as follows:
a) Right click on the upper Fibre Channel Controller and select Update Driver…
b) On the Welcome page, select No, not this time and then click Next .
c) Select Install from a list or specific location and then click Next .
d) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers\x86 .
e) Click OK .
f) Click Next .
g) Click Finish when prompted.
h) In the Found new hardware wizard that will open for the ATTO Phantom device, select No,
not this time .
i) Select Install from a list or specific location and then click Next .
j) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers and select the x86 directory if
installing on a 32-bit computer or the
x64
directory if installing on a 64-bit computer.
k) Click OK .
l) Click Next. .
m) Click Finish when prompted.
5. Repeat the process for the second Fibre Channel Controller as follows:
a) Right-click on the remaining Fibre Channel Controller and select Update Driver…
b) On the Welcome page, select No, not this time and then click Next .
c) Select Install from a list or specific location and then click Next .
d) Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers and select the x86 directory if
installing on a 32-bit computer or the x64 directory if installing on a 64-bit computer..
e) Click OK .
f) Click Next .
g) Click Finish when prompted.
6. Verify that the two "ATTO" devices are now listed under the SCSI and RAID Controllers
7. Close the Device Manager and System windows
Using diagnostic tools
Use the following sections as necessary to identify problems.
72 K2 Summit 3G Service Manual 14 November 2012
Service procedures