Checking pre-installed software, K2 summit 3g system pre-installed software – Grass Valley K2 Summit 3G v.9.0 User Manual
Page 57

Comments
Startup Type
Status
Service
Needed on shared storage K2
Summit 3G system.
Automatic
Started
Grass Valley K2 Config
—
Manual
—
Grass Valley MegaRaid Server
—
Manual
—
Grass Valley MetaDataService
—
Automatic
Started
Grass Valley RTS Config Service
Allows Macintosh systems to
remotely check out a license.
Manual
—
Grass Valley SabretoothWS
—
Automatic
Started
Grass Valley Storage Utility Host
Provides communication with
K2Config. Required on any device
configured by K2Config. Also
provides communication with
STRATUS configuration tools.
Automatic
Started
Grass Valley STRATUS K2
Configuration Service
At startup the Status Server service
makes sure the following services
are started:-AMP TCP
Service-AppService
Automatic
Started
Grass Valley System Status Server
Needed on shared storage K2
Summit 3G system.
Automatic
Started
Microsoft iSCSI Initiator Service
—
Automatic
Started
ProductFrame Discovery Agent
Service
—
Manual
Started
Sabretooth License Server
—
Manual
—
Sabretooth Protocol Service
Checking pre-installed software
Software is pre-installed on K2 products when you receive them from the factory. This load of
pre-installed software is referred to as the “golden drive”. The following list is an example of the
software pre-installed. Check "K2 Release Notes" for the most up-to-date list with version
information.
If you suspect that pre-installed software is not correct, use the recovery process to re-load the
software. Do not attempt to un-install, install, or repair pre-installed software without guidance from
your Grass Valley Support representative.
K2 Summit 3G system pre-installed software
•
Intel Pro Software
•
QuickTime
•
Microsoft iSCSI Initiator
•
MS XML
•
.NET Framework
14 November 2012
K2 Summit 3G Service Manual
57
Service procedures