Grass Valley K2 Summit 3G v.9.0 - Manual (Page 85)

Corrective Actions Possible Causes Problem
Disable Auto Subclip mode. Auto Subclip mode is enabled. On setting mark-out, the subclip
is automatically generated and
ejected, and a new subclip
name is loaded in the subclip
pane.
Use the Playlist Options dialog
instead. You are attempting to use
Configuration Manager to
change what information is
displayed in Monitor Pane for
Playlist. Can’t change what information
is displayed in the Monitor
Pane for Playlist.
Set the control mode for limited
local control. The channel is configured for
control by a remote control
protocol. Can’t control a channel from
AppCenter. Controls are
disabled.
System problems
For the corrective actions in this section, refer to related topics in "K2 AppCenter User Manual" for
detailed instructions.
Corrective Actions Possible Causes Problem
Check the current setting for
video standard. Verify that the
video input signal is the correct
standard. The K2 Summit 3G system is
configured for PAL, yet the
video input is NTSC One of the record channels does
not record or video is jumpy.
Verify the time-of-day source.
Verify the source’s time
accuracy. The time-of-day source for event
scheduling is not accurate. A scheduled event, such as an
automatic play or record event,
does not occur at the proper
time.
Storage problems
Use the following sections if you suspect problems with your K2 Summit 3G system’s storage.
Refer to related topics in "K2 System Guide" for Storage Utility procedures.
14 November 2012 K2 Summit 3G Service Manual 85
Troubleshooting problems