Grass Valley K2 Summit 3G v.9.0 - Manual (Page 93)

Front bezel assembly removal
You can remove the bezel assembly while the K2 Summit 3G system is operating. If you do so,
make sure you replace it within three minutes to ensure that the correct operating temperature is
maintained.
1. To remove the front bezel assembly, proceed as illustrated.
Loosen thumbscrews 1
Slide out 2
2. When installing, avoid pressing the standby switch and accidentally turning the system on or
off.
Disk module removal
Before doing this task, do the following:
• Make sure you have identified the proper disk module. In some cases you must also perform
operations with Storage Utility.
14 November 2012 K2 Summit 3G Service Manual 93
Removing and replacing FRUs