Grass Valley K2 Summit 3G v.9.0 - Manual (Page 69)

NOTE: This procedure restores the K2 Summit 3G system to its factory default condition.
Passwords and other site-specific configurations are reset to factory defaults.
1. Make sure that media access is stopped and that the system on which you are working is not
being used.
2. If you have not already done so, connect keyboard, monitor, and mouse.
3. Do the following:
a) Insert the Recovery Flash Drive into a USB port.
b) Restart the machine, or power on if currently shut down.
The machine boots from the Recovery Flash Drive, into a version of Windows stored on the
drive.
A MS-DOS command window opens.
c) When prompted with a list of options, type 2 to select the Acronis option and then press Enter .
The Acronis program loads.
4. In the Acronis main window, click Recovery .
The Restore Data Wizard opens.
5. On the Welcome page, click Next .
6. On the Backup Archive Selection page, in the tree view expand the node for Removable Disk (D:)
and select the image file, then click Next .
7. On the Restoration Type Selection page, select Restore disks or partitions and then click Next .
8. On the Partition or Disk to Restore page, select MBR and Track 0 and then click Next .
9. On the Disk Selection page, select Disk 1 and then click Next .
NOTE: Verify capacity to make sure you select the boot media card.
10. On the Next Selection page, select Yes, I want to restore another partition or hard disk drive and
then click Next .
11. On the Partition or Disk to Restore page, select (C:) and then click Next .
12. On the Restored Partitions Resizing page, select Yes, I want to resize partitions and then click
Next .
13. On the Restored Location page, select (C:) and then click Next .
NOTE: Verify capacity to make sure you select the boot media card (CompactFlash or mSATA)
and not a media drive. The boot media has a much smaller capacity and has an interface
identified as "IDE (0) Primary Master".
14. On the Restored Partition Type page, select Active and then click Next .
15. Do one of the following:
• If the Restored Partition Size page does not appear. Skip ahead to the Next Selection page.
• If the Restored Partition Size page appears. Continue with the next step.
16. On the Restored Partition Size page, do one of the following:
• If Free space after reports 0 bytes, leave settings as they are. Click Next .
• If Free space after does not report 0 bytes, increase Partition size until Free space after reports
0 bytes. Click Next .
14 November 2012 K2 Summit 3G Service Manual 69
Service procedures