Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 181)

Kayenne XL Package — User Manual 179
System Bars
Machine Control
Figure 120. Machine Control
There are 6 machine control groups on the system bar for panels with 35-
button source selectors.
There are 6 machine control groups on the system bar for panels with 25-
button source selectors.
There are 2 machine control groups on the system bar for panels with 15-
button source selectors.
Each machine control group has a 16-character display showing:
• Short machine identifier
• Selected clip/effect (in clip selection mode)
• Selected still (in still selection mode for RamRecorder channels)
• Selected folder (in folder selection mode for VTRs controlled via LAN)
• Current timecode (in timecode display mode)
Multiple Device Assignment
It is possible to associate one or more devices with a machine control group.
There are two ways to assign a device to a machine control group:
• Hold down Prev and Next buttons together and press (not hold) the
device selection button on the Machine Control module where the
device is assigned to.
• Hold down Prev and Next buttons together and press a source where a
machine is attached to in the Source Selection Module. Attaching a
machine to a source is done with the Kayenne XL Menu
(Config/EBox/Input/General).
If there is more than one device assigned to a machine control group, use
Prev, Next and Play to select a device for control ('bring it on top'):
• To select the next device in the list of assigned devices, hold Next and
press Play.
• To select the previous device in the list, hold Prev and press Play.