Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel - Manual (Page 30)

PDR 100 Fibre Channel Installation
30 PDR 100 Fibre Channel Installation
External Cables Disconnect
NOTE: Making a diagram or note of cable connections will make it easier to
reconnect the cables.
Disconnect the power cord, all cables, and any SCSI terminators from the Profile
rear panel.
Profile Chassis Removal
To remove the Profile chassis from the equipment rack:
WARNING: Unless the equipment rack is adequately anchored, the rack
could tip when the Profile chassis is extended on the rack slides. To avoid
possible injury to personnel or damage to the equipment, make sure the rack
is firmly anchored before extending the Profile chassis on the rack slides.
1. Loosen the Profile chassis retaining screw which secures the Profile chassis
to the rack.
2. Use the Profile chassis front panel handles to slide the chassis out of the rack
until the rack slide locks engage.
WARNING: The Profile chassis is too heavy for one person to remove from
an equipment rack. To avoid possible injury to personnel or damage to the
equipment, get help when removing the Profile chassis from the rack.
3. Being sure to fully support the Profile chassis, depress the slide locks and
slide the chassis out free of the rack and place on a flat level surface with
enough room to work around it.
Covers Removal
There are two covers which need to be removed to gain access to the board area:
the disk drive top cover and the board area top cover. The disk drive cover acts as
a hold down for the board area cover and therefore must be removed first. See
Figure 8.
NOTE: If your PDR100 has been upgraded to 9GB disk drives, it will have
more disk drive cover screws than shown in Figure 8.
!
!